Anyone with an original Big Block that has its original Q-Jet?

[davepl]

In short: Original big block carb doesn't clear original big block linkage - phenolic spacer needed?

I was trying to figure out which linkage type my Q-Jet has to buy the right TV bracketry when I realized that the bottom of the linkage had been cut off by the original owner. That's a problem because I cannot attach TV cable linkage to it now, and need to replace it.

Problem is, it will not clear the intake without that modification. I'm wondering if someone has an original big block setup to check it for me.

The only thing I can think of is that perhaps they should have the thick gasket, but it looks like I already do. Maybe I added that and it wasn't there originally so they had to cut the linkage, but now that I've done it right, I can just repair the linkage arm.

I would really appreciate it if someone has an original they could check, compare, maybe post a photo of.

I've put a side view, front view, and a picture of what the linkage should look like before cut.

Also, can I stick a new linkage rod in here without too much agony? Is it basically like replacing the shaft bore bushings?

Many thanks!
Dave