1967 power steering gear box

[Fitz]

Originally Posted by Classic Heartbeat

Quote:
I always thought all 67 frames were flat in the steering box area.

They are.
WES

No, they are not. My 67 frame is dimpled for the steering box as can be clearly seen in the photo's below. Before you say the frame can't be a 67 with a dimple, the partial vin stamped on the upper side of the frame rail on the drivers side, just behind the steering gear matches the full VIN on the B pillar which decodes as a 1967 C10 six cylinder 1/2 ton built in the Atlanta assembly plant. My truck was #1294 of the first production run which means it was likely shipped in October or November of 1967.