|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-18-2015, 10:11 PM
|
#1 |
|
Registered User
Join Date: Dec 2014
Location: Bristow, OK
Posts: 7
|
Throttle linkeage from firewall to carb
Does anyone know when you can get a replacement rod from the pivot at firewall to the carb? I am running an Endelbrock 1406 on high rise performer manifold. The rod was bent to accommodate an older two barrel setup from previous owner. Straightened it up a bit but am looking for ideas to get one that has not been bent.
|
|
|
| Bookmarks |
|
|
Threaded Mode