|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-02-2015, 07:53 PM
|
#1 |
|
Senior Member
 
Join Date: Mar 2014
Location: Toano, VA
Posts: 882
|
New Ball Joint Install Questions
Been searching for a little and couldn't quite find an answer so I guess I'll go ahead and pose a question.
I'm replacing all my ball joints on my '70 2wd C10, stock drums up front so stock style LBJ & UBJ. How do I press these onto the spindle? Do I just torque the castle nut to spec and they go into place? I know they are tapered in, so how do I get them completely 'seated' I guess you could say. First time working on IFS & ball joints, so I'm very new to this. Also - how do I grease the lower ball joint (since there's no grease port)? Do I just cover the ball joint in grease and add the rubber boot? Sorry for so many questions, I just know how important good ball joint installation is and wanted to make sure I do this once, not multiple times fixing my carelessness..
__________________
"Sometimes I do serve as a good bad example. Glad to be of service." My Build Thread (1967 C10, lowered, EFI, daily truck): http://67-72chevytrucks.com/vboard/s...d.php?t=830809 |
|
|
| Bookmarks |
| Tags |
| 1/2 ton, 1970, ball joints, c10 |
|
|
Threaded Mode