Steering column swap w/cruise - The 1947 - Present Chevrolet & GMC Truck Message Board Network

LeesTruk · 03-17-2015, 04:51 PM

I asked this question in the 73-87 section but I probably should have asked here. I'm swapping the steering column in my '80 C10 2wd shortbed to a unit from an '86 truck w/tilt, auto shifter, cruise. I'm doing this because my stock column has no shifter, and I'm doing a 5.3L/4L60e conversion. Can I just wire the stock cruise switch to the TAC module, or will I have to use a relay system? My engine is DBW. I'll leave the wiper switch in the dash and hi beam switch on the floor. Being period correct is not a necessity, but functionality is.
Thanks

Later...

Lee

03-17-2015, 04:51 PM	#1
LeesTruk Registered User Join Date: Mar 2015 Location: Manchester, CT Posts: 433	Steering column swap w/cruise I asked this question in the 73-87 section but I probably should have asked here. I'm swapping the steering column in my '80 C10 2wd shortbed to a unit from an '86 truck w/tilt, auto shifter, cruise. I'm doing this because my stock column has no shifter, and I'm doing a 5.3L/4L60e conversion. Can I just wire the stock cruise switch to the TAC module, or will I have to use a relay system? My engine is DBW. I'll leave the wiper switch in the dash and hi beam switch on the floor. Being period correct is not a necessity, but functionality is. Thanks Later... Lee



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.