|
04-14-2015, 05:26 PM
|
#1 |
|
I am a Referee of life.
Join Date: Jun 2000
Location: Greensboro N.C.
Posts: 13,992
|
'Burb rocker panels
Has anyone done a set of rockers on a 'Burb/Panel? I'm trying to fit a new one and it doesn't seem to be "deep" enough. The top fits much better than I expected but the bottom curve doesn't work out. Either the curve lines up but the "pinch weld area" doesn't reach the inner or the inner fit's up(almost perfectly) but the curve is off of the body line. I asked in the body forum but didn't get any answers or even speculation.
If it even quits raining I will measure and take pics.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil" |
|
|
| Bookmarks |
|
|
Threaded Mode