Drive Shaft Center Support Bearing

[dmw319]

Originally Posted by Davidf

I recently replaced the center support bearing and it was very easy. I cannot fathom the need to have someone else do this very simple task. Just mark the relationship of the two driveshaft sections relative to each other. Remove the u-joint, remove the yoke bolt. Drive off the support bearing (used a chisel). Install new bearing and use bolt to press it on (ensure you have the alignment marks matched up). Install u-joint and done. No balance issues because nothing was changed.

thanks, this was more what I was thinking. what do you mean by 'use bolt to press it on'?