61K10 build

[61K10]

Well haven't done much to the tk, been putting new cabinets in my kitchen, then the hot water heater quit working. Had to replace it as it was 17yrs old.

But i did manage to re-build a third member with 3.38 gears. Used a spare bearing with the ID hoged out so it would slide on the pinion to set pinion depth. used the toaster oven to heat the new p-bearing and froze the pinion--slid right on with a little tap. Probably temp till i build a complete new axle. 12B? or a custom Toyoda land cruiser as they look the same as the eaton. they even have the same rear cover and is a drop out. In less somebody has a new 3.90 r&p--ya right.