![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jan 2010
Location: Loveland, CO
Posts: 1,921
|
4WD Front hub question
Earlier today I tore down the front brakes/hubs on my K2500 to replace the rotors, and when I got everything apart I noticed that the right side had a shim on it that the left side did not. The shim was underneath the outermost piece with the dial in it. I'm assuming that both sides should have this shim correct? And are there supposed to be any gaskets or seals between the sections of the hubs? The last person to have this apart just put a thin layer of silicone, which worked fine, I'm just curious about the correct way these should be sealed up. Thanks for any info
![]()
__________________
Zach 1970 Chevrolet Custom Camper K20 1971 GMC Super K2500, 12V/NV4500 swap in progress 1971 Chevrolet Custom C10 1972 Chevrolet Custom Deluxe C20, 5.3/4L60E 1972 Oldsmobile Cutlass Supreme, 455/TH400, 3.73 posi 2004 GMC Sierra 2500HD, LB7/Allison, CCSB 2005 GMC Sierra 1500, 5.3/4L60E, CCSB |
![]() |
![]() |
Bookmarks |
|
|