The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1947 - 1959 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-01-2015, 05:19 PM   #1
Atommik
Registered User
 
Atommik's Avatar
 
Join Date: Sep 2011
Location: Golden Valley,MN
Posts: 639
Door trim panels

I am making my own full door length, door trim panels. I'm using the original style interior door handle and window crank handle and Altman latches. I can see that when I attach the trim panel, the flat bar that connects the inside handle to the latch will rub on the inside of the trim panel causing it to bind while opening the door from the inside. If I make an "edge" around the inside of the door trim panel it would give some clearance, but then I think it would be too hard to attach the inside handle to the shaft because of the thickness of the panel. Any ideas how to solve this dilemma?
Atommik is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:34 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com