|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-09-2015, 11:07 PM
|
#1 |
|
Registered User
Join Date: Aug 2014
Location: kentucky
Posts: 111
|
Another Temp Gauge Question
My temp hand is pegged on H.
I ran a ground wire from the bottom nut on the gauge to the windshield wiper nut (just to see if it moved) it smoked the printed circuit board. I can see where it burned the copper wire on the circuit board. I'm going to buy a new board tomorrow . Is there anything else I should buy and/or do while I have the dash cluster out . I don't want to buy one and trash it again . Why did it burn it when I touched it to the wiper nut ? 
|
|
|
| Bookmarks |
|
|
Threaded Mode