Need some door help..

[62step]

I tried to go the cheap route on my doors and it was a mistake.. I tried to weld some sheet metal in instead of panel the patch panel, I wanted to get it done quick and it's now warped almost half way up the door. It's very embarassing so I won't post pictures, so..

Should I drill all the spot welds out around the bottom and buy a inner door skin and outer door skin to try and fix it the right way? Or is there another route? Buy a new door (I cna't find any manufacture that makes new 60-62 doors), I guess I'll have to go with used if I choose this route.

Maybe once I cut this crap out I might post them. I'm just afraid I ruined the entire door because I let too much heat in one spot. Thanks for any advice!

Mike