PA I6 power steering pump with brackets and pulleys - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**1rippen6** · 12-04-2015, 10:27 PM

Removed this from an early 70's nova doesn't look the same as the trucks but appears that it mounts the same. It looks like the truck setup has 2 pulleys for the wp and 2 for the crank but this setup had an additional groove on both so I grabbed them encase the pump ran on them. The hoses were already gone and the pump spins fine but don't know if it works. Please make sure you know that it will work for your application because I will not. 125 shipped for everything. SOLD

12-04-2015, 10:27 PM	#1
1rippen6 Senior Member Join Date: May 2011 Location: Greencastle PA Posts: 6,807	I6 power steering pump with brackets and pulleys Removed this from an early 70's nova doesn't look the same as the trucks but appears that it mounts the same. It looks like the truck setup has 2 pulleys for the wp and 2 for the crank but this setup had an additional groove on both so I grabbed them encase the pump ran on them. The hoses were already gone and the pump spins fine but don't know if it works. Please make sure you know that it will work for your application because I will not. 125 shipped for everything. SOLD Attached Images Last edited by 1rippen6; 12-05-2015 at 02:58 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.