1976 Square "Simple Green"

[RodsGreen10]

Well ran into a issue with the an fittings going on the FiTech EFI. I want to run my fuel line and return line like it would be on a carb. Meaning enter and exit on the passenger side. So with a 45 or a 90 an fitting it was hitting my drop base on my air cleaner. I have a 1.25 drop base. So the only way this would work would be put the inlet fuel on the front or rear drivers side of the FiTech and angle the fitting towards the middle you would have to do the same to the return on the passenger side as well. Well I did not want to run the fuel line across the front of the FiTech or run the return line and put a bend in the line to run it back to the passenger side or run the return all the way around to the drivers side then around the front so it would make it back to my tank on the passenger side. So I just order another base and a 3" filter. So this is something you all might need to know. If using a drop base and give a crap about a clean install. I will not put a 90 degree fitting unless I absolutely must. 45 is better for fuel flow. So what I have left is the tank and waiting on the base. Got the 2 fan wires hooked up the ac wire hooked up and the o2 sensor installed.