So I bought a Helix IFS kit...
I know, I know. I PROBABLY should have done more homework, but it's here now, and I'm not going to pay shipping and restocking fee. It's going on my 58. Don't scold me too bad. Lol.
Does anyone have experience in making good measurements on notching the CM and top hats? Is the main idea to get the lower CA to be parallel to the ground at ride height? The kit I got is a bagged kit.
The stuff doesn't look that bad. The welds on everything I received were left untouched. And looking on the back side of the welds looks as if there is adequate penetration. My only complaint is the bubbly rotors Johnny law sent (we're working that issue), and the lack of sway bar, but I'm gonna fab my own kit and adapt it in.
|