64' K10 Project Long Bed - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**aotte1** · 01-10-2016, 03:29 PM

MG,

It was all pretty easy. Did both apart and parts labeled for Dana 44 and 12 bolt in a little less then 2 hours.

It was not hard, all the hubs stuff came out easy, and carrier was not hard. Used impact to get pinion nut loose. It was kind of tight, however, gave up and came loose after a bit.

Now putting Dana back together will likely take some time to get it adjusted?? Maybe lots of trial set-up, this is first Dana 44.

Les

01-10-2016, 03:29 PM	#10
aotte1 Registered User Join Date: Oct 2013 Location: lousiville Ky Posts: 2,645	Re: 64' K10 Project Long Bed MG, It was all pretty easy. Did both apart and parts labeled for Dana 44 and 12 bolt in a little less then 2 hours. It was not hard, all the hubs stuff came out easy, and carrier was not hard. Used impact to get pinion nut loose. It was kind of tight, however, gave up and came loose after a bit. Now putting Dana back together will likely take some time to get it adjusted?? Maybe lots of trial set-up, this is first Dana 44. Les



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.