64' K10 Project Long Bed

[aotte1]

Kimble,

In the latter category, replacing gears, and likely bearings too. Have not cleaned all the bearings, yet to decide? Both Spindles, as bearing were run to loose and they are worn. I call them spindles, not sure if correct name. Photo of them in post 190.
Did you set yours up with new parts, or get to use original parts?

Have you R/R ed your rear springs yet? Plan to get back to you with questions on parts used to rebuild rear shackles e.g. Bushings and pins. These parts described in your build, Ron may have provided some comments.

Need to see if LMC parts are compatible, as Eddie is sending me some LMC parts.

Thanks,
Les