Another Pinion Angle question I'm back! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

1LowToy · 01-10-2016, 07:45 PM

Well after a long battle with working on the house I'm back to working on the truck. I did a flip of the rear end and have new perches to be welded on. I have it set at about 6 degrees, pinion down. Several people have said 2, 3 or 4 degrees down is fine. How about 6? I just hate to loosen everything up again for a nats ass

Yey Ney or????????

I may just have I welded up as is and may shim or shave down the lowering block.

01-10-2016, 07:45 PM	#1
1LowToy Registered User Join Date: Nov 2009 Location: Sonora California Posts: 860	Another Pinion Angle question I'm back! Well after a long battle with working on the house I'm back to working on the truck. I did a flip of the rear end and have new perches to be welded on. I have it set at about 6 degrees, pinion down. Several people have said 2, 3 or 4 degrees down is fine. How about 6? I just hate to loosen everything up again for a nats ass Yey Ney or???????? I may just have I welded up as is and may shim or shave down the lowering block.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.