![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jun 2013
Location: Grand Rapids Michigan
Posts: 291
|
Eaton HO52 pinion bearing slop
Hey all,
I replaced the pinion seal on my HO52 rear axle following the instructions I took from this site. Before I took the pinion nut off I recorded exactly how many threads were showing and marked were the nut was in relation to the pinion. I put everything back together and everything seemed tight. No slop in the yoke so I figured I was good to go. At this point I only had a rolling chassis. Today, now 6 months later I noticed that there is a lot of slop in the pinion. I can move the yoke up and down a considerable amount. It's still a rolling chassis (no driveshafts) so I don't see how it could have been worn at all from just rolling back and forth in my shop. What's my best course of action here? Do I just tighten the nut until there's no play in the yoke?
__________________
My build thread: http://67-72chevytrucks.com/vboard/s...96#post7439296 |
![]() |
![]() |
Bookmarks |
|
|