You gotta help me out

[Coupeguy2001]

Well, it's a plea to help.

My storage unit is about to go away. The people sold it to U-Haul, and it is likely that I won't have it any more.
I need to sell some stuff.


scroll down for pictures of some of this stuff.


I have things like:
4 bolt main 350 engine,
a 327,
Corvette TPI intakes,
corvette 700R4 transmissions,
I have a 12,000 mile 96 corvette rear end that is a 3.07 that I want $1500 . It is complete except for the spring.

engine mounts that are the corvette kind that are encased in steel so they won't break,
power steering pumps, vette and non corvette.
1986 Corvette wheel hubs/bearings
serpentine brackets


Task force inside door trim, front cowl vent, wipers, wiper arms, transmission arms, CPP steering kit, leaf springs, front axle, rear axle, pumpkins, spider gears, wheel bearings,

task force flywheels, clutches, flex plates, ignition coils, new throwout bearings, etc, etc, etc.

I have some 16 inch used corvette tires, 255/50/16,

70's and 80's starters, alternators,

a 70 truck full synchro 3 speed trans that is a bolt in to the task force trucks,

I would hate to scrap this stuff. it is all good stuff.
That would be so irresponsible to do that.
make you a deal.......
All this stuff is from Arizona, California cars, no rust. Some of the stuff still has the factory paint on it and doesn't look too bad.

For those of you that have corvette suspension for your truck, I have a Complete polyurethane bushings kit for $150. 1986 front discs, exhaust, brackets, pulleys, etc.
Most of this stuff was purchased to support my truck and C4 corvette. When all of this is gone, the corvette will have to go too.

message me, or call,

602-510-2519