Reed 78 FJ40 Rebuild

[reaper71]

Pic #1. Here is the rear mount for the new transfer case,The customer felt this was a bit to close for comfort if the trans and case needed to come out at a later date,so it would be removed.

Pic #2. After it was removed giving me the needed room for easy removal.

Pic #3. The scab plate welded to the frame for more strength and ready for the mount.

Pic #4.Motor mounts and all the transfer case mounts in and final.
Ready for exhaust.

Pic #5. This is the first shot of the exhaust mock up. I'm using block hugger headers from speedway and the tubing is 2 1/4 kit from speedway it comes with 4 u bends,4 45's,4 90's and 4 straight pipes for $140.00.

Still need to do my final weld on the front sections and then will start on the back section after the mufflers.
More to come.


Mark...