|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-01-2016, 12:42 PM
|
#15 |
|
Registered User
Join Date: Apr 2015
Location: Ayr Ontario
Posts: 1,122
|
Re: rear outer wheel well question
I use 19 ga steel and bend it on my table edge. 1 inch thick solid steel 22"x33" table top. The edge of the wheel well I bent with a bar, 1/2 " deep cut as shown in pic. I cut the old well out and used it as the template. I drilled holes to spot weld the upper edge, fit it under the bottom on the well and tacked that edge together.
|
|
|
| Bookmarks |
|
|
Threaded Mode