What to do with with bed... Fix steel floor or go with wood floor? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**70cst** · 03-05-2004, 08:43 AM

I am about to have one good bed made out of two beds. My bed has good sides and front but the floor is shot. I have a Tx bed I was going to use as a donor. (Use its floor and my sides.) The sides and front of the Tx bed is junk but it has a great rust free floor. Then I started to think...(ouch) Would I be better off converting to a wood floor? It will cost about $1000 to have the bed taken off...make two beds from one...and put back on the truck. Which is the best bang for the buck. I await your advice, suggestions, and opinions. Your humble truck enthusiast.
Regards,
70cst

03-05-2004, 08:43 AM	#1
70cst Senior Member Join Date: Feb 2001 Location: New Madison, Ohio Posts: 21,365	What to do with with bed... Fix steel floor or go with wood floor? I am about to have one good bed made out of two beds. My bed has good sides and front but the floor is shot. I have a Tx bed I was going to use as a donor. (Use its floor and my sides.) The sides and front of the Tx bed is junk but it has a great rust free floor. Then I started to think...(ouch) Would I be better off converting to a wood floor? It will cost about $1000 to have the bed taken off...make two beds from one...and put back on the truck. Which is the best bang for the buck. I await your advice, suggestions, and opinions. Your humble truck enthusiast. Regards, 70cst



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.