|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-28-2016, 08:41 PM
|
#11 |
|
Registered User
Join Date: May 2013
Location: Mississippi
Posts: 501
|
Re: 1987 R20 Suburban LQ4 4L80E swap
Sorry I haven't posted in a bit.
The Suburban is home now after having the driveshaft and exhaust wrapped up. Today found a couple hours to get some things done on the suburban. Installed the radiator and realized it is still an inch or so too short! Ordered some side mount radiator brackets from LMC hope these will work, if not going to have to get creative and go to Home Depot and see if I can make something. Also found out the nipple on the back of my intake manifold for my brake booster is larger than the nipple on my brake booster so have to figure something out there. Any suggestions? Got my regulator/filter installed and installed all the fittings for the fuel system and trans cooler lines. Also replaced the inline fuel filter under the truck.
__________________
 1987 R20 Suburban LQ4/4L80e swap: http://67-72chevytrucks.com/vboard/s...d.php?t=693824 Last edited by Nodnarb76; 03-28-2016 at 08:53 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode