72 K30 Build

[7dee2]

Hey now that's a thought Mike, uh no! But thanks for the suggestion.


This setup has got to save us some gas don’t you think?

Mating an 850 double pumper to the old spread bore performer using a couple of square base gaskets and a 1/8” square plate in between is not quite enough to clear the primaries so a little shave on the center divider will get us the rest of the way. Our factory type breather setup to the air cleaner base we are going to run can’t accommodate a large adaptor/spacer because of the angle it will create, also I believe the divided plenum helps with low end torque. So I’m trying to keep as much of the intake divider in place as possible. Soaking some areas with gunk before a trip to the solvo sink hoping it cleans up good enough and that it doesn’t have to be painted.