Lucy gets a modern powerplant

[LooseyLucy71]

Originally Posted by zteca

I really dig your ECM bracket, any other pictures showing how you mount it or where it mounts to?
Keep up the good work

Thanks! it's tough to get a good picture in there, but both the PCM bracket and fuse box plate are bolted in with the two bolts that hold the brace between the radiator support and outer fender. On the PCM bracket I removed the screws that hold the PCM together and dropped the mount in and put the screws back. I figured this was easier than trying to fully encase it. You can see this in Post 42, pictures 2,3. I'll attach one more pic, but I'm not sure if it's what you're looking for.

I will say this is not the easiest setup service-wise, but I'm going for a clean look, so I'm dealing with that struggle for now.

Since the last post I've added 3 relays to the backside of the fuse box / relay plate. It's tight, but they fit right behind the relays you can see in my last post, just pulled the screws and added relays behind. The fans are mounted and I tested them to make sure they work and get + and - sorted out. Exhaust is done, O2 sensors are installed and wired, serpentine belt is on, and we're working on radiator hoses and fan wiring. I've been super busy, but I'm so close to being back on the road I'm trying to get down to the garage every spare minute!