![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Oct 2004
Location: Turner Valley, Alberta
Posts: 91
|
70 K15 lower ball joint- no snap ring?
I am replacing the BJ's in my 70K15. Removing the lower ball joints, they did not have snap rings holding them. The replacements are not long enough to have that snap ring engaged in the knuckle. Old and new BJ's show the same overall measurement on the mic. Am i good to install them without the snap ring? After opening the boxes, i see that one of them is splined. Is there a difference with the splined vs non-splined? It wont be a serious 4-wheel machine, but still want it to be right.
Any suggestions would be a help.
__________________
1970 GMC K15 - Canadian built 2nd Owner truck 68k miles ![]() 2014 Denali 1500 6.2L ![]() ![]() |
![]() |
![]() |
Bookmarks |
|
|