New timber bed build and some other stuff

[Ben Moras]

I Thought i might add some pics and a list what i have done so far since buying my truck,

#Fix blinkers and dash lights and interiors light
#reconnect old radio and replace speaker
#replace heater core. install hoses,dash vent, ducting (were missing from PO)
#install cigarette lighter mainly for look and phone charging
#replace drivers door hinge pin
#attach kick down cable and vacuum hose
#remove 3rd muffler and put pipes out the side in front of back wheels
#replace engine mounts
#replace extractors with newer better fitting set
# fix hand brake cable so it works
#relocate rear shocks and make full set of mounts top an bottom
#polish rims using mothers power cone
#replace timber bed using Australian iron bark that i milled and worked myself
#remade custom bed sills as they were missing
# move bed forward into correct position
#install a carburetor riser to help with heat soak
#rebuild Edelbrock 1406 with full rebuild kit plus rejet using jet kit
#replace throttle linkage with one that actually works. the one that was on it was rough to say the least
#install column shift mounted Tacho
#replace vacuum advance module
#fuel pressure reg installed
#replace front bumper with Crome
#purchase rear bumper, (Not Fitted)
#hand paint the CHEVROLET letters in the grill
#adjust the power steering
#Purchase full front clip (just in case i want to repaint?)

I thought that be the end, but i have already started to think about what else i want to do. it seams it never ends. ha ha
any way loving the truck. pics and descriptions to follow