85 tie rod taper worn

[SquareBox86]

Started putting my front end together, LH TRE looked good, RH side the TRE goes too far up into the knuckles taper...cotter pin hole is above the nut. I looked for a bushing type fix online but nothing really. People run the 1 tons I see but I rather fix this knuckle since it's all mounted and cleaned up if I could. Plus who knows what another used ones will be like, I actually have a parts truck and it is exactly the same way...lh side is ok and rh side the cotter pin is above the nut and the rubber is crushed. Could throw a washer under the nut I guess but that would be hack...any fix ideas? Rh tre is a es2011r, pics are of lh and rh, tre's are just pushed up by hand and nut snugged