Vintage air controller (oem) question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Sklptrljay · 10-09-2016, 12:41 AM

Quick question.... (VA and my vendor are gone for the weekend and i'm just too impatient too wait until Monday to figure this out)

I just received my Gen IV system, and they sent me the kit for a non-air cab using a heater only controller. I ordered the kit for using a OEM A/C controller. Looking at the packing lists for both kits, the only real difference I see is a bracket that mounts to the bottom of the controller. What is the purpose of this bracket?

If not needed, it looks like I can use what they sent me, and just use the other instructions off their site.

10-09-2016, 12:41 AM	#1
Sklptrljay Registered User Join Date: Apr 2012 Location: Stillwater, Oklahoma Posts: 874	Vintage air controller (oem) question Quick question.... (VA and my vendor are gone for the weekend and i'm just too impatient too wait until Monday to figure this out) I just received my Gen IV system, and they sent me the kit for a non-air cab using a heater only controller. I ordered the kit for using a OEM A/C controller. Looking at the packing lists for both kits, the only real difference I see is a bracket that mounts to the bottom of the controller. What is the purpose of this bracket? If not needed, it looks like I can use what they sent me, and just use the other instructions off their site. __________________ 1971 C/10 SWB, 15x8 Rallys, 4.5" X 7" static drop, C-notched, 350/350, 3.73 Posi. .........A 383 and Gear Vendors are on my bucket list. 1972 GMC 4X4 K1500 Survivor - Sold No matter what problems life throws at you, your time on Earth can be incredibly fulfilling and rewarding.....if you just lower your expectations. -Phil Dunphy



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.