![]() |
![]() |
#1 |
Registered User
Join Date: Aug 2015
Location: Kelowna, B.C, Canada
Posts: 1,747
|
Pinion angle question
So I am putting a 12 bolt under my 62, I just got the mounting pads cut off the rear end and I'm just about ready to weld the brackets back on in the correct location but I'm unsure of what to set the pinion angle at since I currently have a two piece driveshaft, but I will likely be switching to a one piece very soon. what I am asking is if a one piece and two piece require different pinion angles? Thanks
__________________
Nik...................____ 62 lwb c10 step-side 261 5 spd .........________//__{\_____ ,,,,,,,/__(O)___//___/__(O)_/ my build thread. Sending unit solution |
![]() |
![]() |
Bookmarks |
|
|