11-01-2016, 09:32 PM | #1 |
Registered User
Join Date: Nov 2012
Location: San Jose California
Posts: 196
|
Intermediate Shaft
I want to use the intermediate shaft and column from a 1971 on my 65 C10. I want to use a U-joint to replace the factory grease knuckle between the steering column and the collapsible intermediate shaft. The collapsible shaft has a pin, sleeve, and a pot. Do i just remove the pin and sleeve and use a 3/4" smooth to 3/4" 36 spline u-joint and use the existing hole to anchor the u-joint? Or do I cut the lower portion where there is a "DD" 3/4 design and use a 3/4" DD to 3/4" 36 spline u- joint?
|
Bookmarks |
|
|