Brake push rod clevis pin configuration? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**71CHEVYSHORTBED402** · 11-05-2016, 07:21 PM

Not exactly critical, but I'd like to know which is right.

My 71 was Clip > Plain washer > Tension washer. The dome portion of the tension washer was facing the RH side of the truck. I least I think it was (whoops).

This is a picture of my 72. The washers are flipped and the dome portion of the tension washer is facing the other way.

Thank you.

EDIT: Go figure there's another of the same set underneath. Didn't see it. That's set up on my 71 just as the top was. I'm guessing the 72 (pictured) may have had the booster replaced, and they did it wrong.

11-05-2016, 07:21 PM	#1
71CHEVYSHORTBED402 Senior Member Join Date: Feb 2009 Location: Northern Nevada Posts: 7,205	Brake push rod clevis pin configuration? Not exactly critical, but I'd like to know which is right. My 71 was Clip > Plain washer > Tension washer. The dome portion of the tension washer was facing the RH side of the truck. I least I think it was (whoops). This is a picture of my 72. The washers are flipped and the dome portion of the tension washer is facing the other way. Thank you. EDIT: Go figure there's another of the same set underneath. Didn't see it. That's set up on my 71 just as the top was. I'm guessing the 72 (pictured) may have had the booster replaced, and they did it wrong. __________________ Tony 71 Custom Deluxe, SWB, 2WD, 402, A/C. I developed an assembly kit for restoring the (a) truck from the ground up. My build thread, and more on the assembly kit https://67-72chevytrucks.com/vboard/...d.php?t=730025 Last edited by 71CHEVYSHORTBED402; 11-05-2016 at 10:44 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.