|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-13-2016, 02:16 PM
|
#9 |
|
Registered User
Join Date: Jul 2015
Location: North East PA
Posts: 685
|
Re: Need carb help bad....please please
As per endelbrock instructions , pull top of carb off adujust float height using 7/16 drill bit ,pull adjustment screws out blow the ports out with a small amount of compressed air, run adjustmenscrews back in then 1.5 turns out starting point, clean bowl and power vents , put top half of carb back . start engine and adjust carb after warm up...
|
|
|
| Bookmarks |
|
|
Threaded Mode