Z bar/pivot ball dilema - The 1947 - Present Chevrolet & GMC Truck Message Board Network

dubie · 03-24-2004, 01:22 PM

OK I got a V8 Zbar from fellow board member gr8scott51 (many thanks again scotty) and I seem to have run into a pivot ball location problem. The first pic shows where I assume there should be a hole in the block to accomodate the pivot ball. But as you can see there is no hole in the block. The second pic is a pic of a threaded hole, farther back on the block near the bell housing. This , I assume is where the pivot ball should go if the engine was in the factory V8 position. ANy help out there??

Pic 1

03-24-2004, 01:22 PM	#1
dubie Registered User Join Date: May 2000 Location: Flin Flon, Manitoba, Canada Posts: 8,855	Z bar/pivot ball dilema OK I got a V8 Zbar from fellow board member gr8scott51 (many thanks again scotty) and I seem to have run into a pivot ball location problem. The first pic shows where I assume there should be a hole in the block to accomodate the pivot ball. But as you can see there is no hole in the block. The second pic is a pic of a threaded hole, farther back on the block near the bell housing. This , I assume is where the pivot ball should go if the engine was in the factory V8 position. ANy help out there?? Pic 1 Attached Images __________________ My name's Tim and I'm a truckaholic My 56 Chevy shop truck build http://67-72chevytrucks.com/vboard/s...d.php?t=562795



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.