Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
03-24-2004, 01:22 PM | #1 |
Registered User
Join Date: May 2000
Location: Flin Flon, Manitoba, Canada
Posts: 8,855
|
Z bar/pivot ball dilema
OK I got a V8 Zbar from fellow board member gr8scott51 (many thanks again scotty) and I seem to have run into a pivot ball location problem. The first pic shows where I assume there should be a hole in the block to accomodate the pivot ball. But as you can see there is no hole in the block. The second pic is a pic of a threaded hole, farther back on the block near the bell housing. This , I assume is where the pivot ball should go if the engine was in the factory V8 position. ANy help out there??
Pic 1
__________________
My name's Tim and I'm a truckaholic My 56 Chevy shop truck build http://67-72chevytrucks.com/vboard/s...d.php?t=562795 |
Bookmarks |
|
|