Started my project on my 68 shorted c10. Going to run full porterbuilt stage 3, 6.2ls3 4l75e drive train, Patina body. Same as everybody it seems right now... I have the truck all torn down to the frame and was getting ready to get sandblasted but noticed the frame looks a little tweaked. The truck doesnt show any signs of being in a major wreck but does have some bad body work done where it looks like it was dented in the back rear. (only downfall of the truck ) Also the firewall has separated from the cab floor on the passenger side. I have measure in a X pattern in the same spot and it is within a 1/8th of a inch. When I say it looks tweaked it looks like the back driver is sitting higher than the passenger. I will say that my jack stands are not perfectly level and it can be straighten by pick up on it. Is this normal? With porter built on the way I want to make damn sure its a straight frame before I go taking out cross members and installing.
[IMG]
[/IMG]
[IMG]
[/IMG]
[IMG]
[/IMG]
11-30-2016, 12:22 AM
[/IMG]
[/IMG]
[/IMG]
Threaded Mode