Tie Rod question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

WB72 · 03-31-2004, 12:32 AM

Gents,
What are the differences in the tie rod ends between a 72 C20, 72 C10 and a 73-87 1/2 ton?

The reason I am asking is I am converting my C20 to a dropped C10, the spindle maker requires me to use 73-87 ball joints and tie rod ends, will the outer fot into the C20 sleeve? If not will the 73-87 tapered end fit in the C20 steering arm (the one that connects the two sides if the truck)?

In short will I have to purchace the inners as well as the adjusting sleeve?

Will I have to get a new steering arm?

Are the treads the same? Is the taper the same?

03-31-2004, 12:32 AM	#1
WB72 Before and After Join Date: Feb 2000 Location: Leduc, Alberta CANADA Posts: 632	Tie Rod question Gents, What are the differences in the tie rod ends between a 72 C20, 72 C10 and a 73-87 1/2 ton? The reason I am asking is I am converting my C20 to a dropped C10, the spindle maker requires me to use 73-87 ball joints and tie rod ends, will the outer fot into the C20 sleeve? If not will the 73-87 tapered end fit in the C20 steering arm (the one that connects the two sides if the truck)? In short will I have to purchace the inners as well as the adjusting sleeve? Will I have to get a new steering arm? Are the treads the same? Is the taper the same? __________________ Not Grandpa's C-20 anymore... 383 Stroker 425HP, 485Ft/Lbs Lowered 3.5" Front / 5" Rear 66,000 miles. Alberta, CANADA



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.