|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
07-17-2017, 09:15 PM
|
#1 |
|
Registered User
Join Date: Dec 2010
Location: Sherwood, Arkansas
Posts: 156
|
Front to rear brake line replacement
So today I decided to change out the blown rear rubber brake line on my '68 Chevy short bed. While doing so, I managed to brake the hard line thats on the back side of the frame. Pretty sure it was rusted and bad anyway.
My question is, should I just by a new, pre bent one from LMC, or build one? Also, besides a new clip set to hold the new line in place, what else should I buy and or replace? |
|
|
| Bookmarks |
|
|
Threaded Mode