![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jun 2013
Location: Grand Rapids Michigan
Posts: 291
|
TH400 rebuild: Output shaft difficult to turn
Hey all, I'm in the middle of rebuilding my 2wd TH400 and everything is going great except for the fact that I can hardly get the output shaft to turn by hand. Even with none of the clutches installed it was pretty difficult (requiring 2 hands), and now that everything but the pump is installed I can't get it to move without a lot of grunting and cussing.
My guess is that the tailshaft bushing isn't installed perfectly straight, or maybe it has a bit of a lip from when I installed it. Either way, do I have to rip this thing down and start over? Or is this considered normal? Tailshaft end play is in spec, so I don't think it's binding laterally... Thoughts?
__________________
My build thread: http://67-72chevytrucks.com/vboard/s...96#post7439296 |
![]() |
![]() |
Bookmarks |
|
|