|
04-03-2018, 07:27 AM
|
#1 |
|
Old member
Join Date: Jan 2002
Location: Liberty, & Garden City S.C. , U.S.
Posts: 19,945
|
Adding to the C20
I got the spare 2-6 volts hooked up to the winch so I started on my next little project.
AIR: I bought a older air ride system back several years ago that I was going to install on my 71 C10 but never have and probably never will. I decided the ramp needed a air supply so. I put together a small system to supply air if needed on the road. Going to have 120PSI when done on a 3 gallon tank with a auto cutoff for it. Going to run the hot off the contactor for the winch to a relay to power it then to the pressure switch then to compressor. I wire so it only has 12 volts when the truck is running. Will mount everything under the bed and have brackets for the compressor to sit level. 
__________________
1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs. |
|
|
| Bookmarks |
|
|
Threaded Mode