New here and need some help

[Carole67]

I am new here and need some assistance, bought a 67 C10 stepside, I am in the process of redoing it for my gal. As i am tearing it down getting stuff cleaned up and some sent to powercoat, i noticed some discrempencies in the frame, # 1 the bumper horns were cut off and a roll pan install so got some frame horns and a bit different

2nd where the core support was bolted to the fram and not riveted was lower and back than original position at top of frame, and it had cab type bushings, my frame does not have 4 bolt holes or rivets to hold core support bracket on it has 3 2 on top and one in the center

found a frame number on drivers side top in front of motor mount brackets H152189

It is a coil spring rear frame. i want to make this right just trying to figure out what i got so i can go from there. i was told by a friend who is on here that you guys can help.

Thanx Mike
http://67-72chevytrucks.com/vboard/a...1&d=1522960845
http://67-72chevytrucks.com/vboard/a...1&d=1522960845