|
04-11-2018, 04:47 PM
|
#1 |
|
Senior Member
 
Join Date: Jan 2016
Location: Sugar Hill GA
Posts: 369
|
Oil pressure port
I am changing the oil pressure gauge to an electrical one. I pulled the copper line off the fitting at the back of the block but it left a brass treaded fitting in the block. There is no hex head or screw driver slot to try to get this out. Any suggestions? Worse comes to worse I could put some vice grips on it but I don't want it to break off. Also from what I have read this fitting is a 1/8" NPT, is that true?
__________________
1967 C10 Step side 1970 AMX 390 1977 Datsun 280Z highly modified with '95 LT1 power |
|
|
| Bookmarks |
|
|
Threaded Mode