|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-15-2018, 01:06 PM
|
#1 |
|
Registered User
Join Date: Jun 2011
Location: Marion, NC
Posts: 851
|
62 c20 step notch placement question
Starting to mock up my welderseries step notch on my 62 and I was wondering if I need to just center it up over the axle or push it a little forward (I think?) to compensate for the arc of trailing arms. The notch is only 3 1/2 inches wide at the top so not a ton of room for error.
Thanks! |
|
|
| Bookmarks |
|
|
Threaded Mode