Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
06-28-2018, 05:36 PM | #5 |
Registered User
Join Date: Jan 2014
Location: Moreno Valley, Calif.
Posts: 244
|
Re: 1957 Bellhousing crossmember
On my 55 2nd V8 I cut the crossmember about 6in on each side, from the frame, and removed it. I have a full circle aluminum bellhousing and could not access the clutch with the crossmember in there. Like Mike, I have a crossmember at the rear of the trans and under the mid of the engine as well. Been a couple of years, and no problems yet....
__________________
'55 Chevy 1/2ton pickup w/ Pontiac 350 and Muncie M21 close ratio 4speed "Red Ryder" |
Bookmarks |
|
|