factory steering wheel installation issues - The 1947 - Present Chevrolet & GMC Truck Message Board Network

macdaddy70 · 08-11-2018, 10:01 AM

1970 GMC...pulled the OE steering wheel (non tilt) to install a new hazard switch. I go to install the wheel and cant get the splines to align for the wheel to slip onto. It will slip over splines without the cancel cam but does not want to with the cam installed. I have 1 thread exposed with the wheel and could torque it with a ratchet, but I figure that will do more harm than good. I have been struggling with this for a while...I just want to drive. Any suggestions?

08-11-2018, 10:01 AM	#1
macdaddy70 Registered User Join Date: Aug 2013 Location: Gluckstadt, MS Posts: 71	factory steering wheel installation issues 1970 GMC...pulled the OE steering wheel (non tilt) to install a new hazard switch. I go to install the wheel and cant get the splines to align for the wheel to slip onto. It will slip over splines without the cancel cam but does not want to with the cam installed. I have 1 thread exposed with the wheel and could torque it with a ratchet, but I figure that will do more harm than good. I have been struggling with this for a while...I just want to drive. Any suggestions?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.