Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
10-01-2018, 06:30 AM | #1 |
Registered User
Join Date: Sep 2018
Location: Newcastle, New South Wales, Australia
Posts: 139
|
Drive line phasing question. 70 C20 manual.
Hi all,
On the weekend I replaced the centre bearing (tailshaft support) I was not thinking and didn't pay attention to the phasing of the uni joints between the front and rear shafts. I lined them up as I have always done, same as the attached photo,but now I have a vibration that comes in at 25-30mph and stays until 40,the comes back again at 50. I am sure it's driveline, it didn't have it before. Is there something different about the chev? It has the 465 4speed manual and stock 4.57 diff. I lined up the centre bearing central to the mount. The workshop manual only has larger truck shafts in it, no smaller trucks shown. Any tips would be great. |
Bookmarks |
|
|