Fitech throttle linkage help - The 1947 - Present Chevrolet & GMC Truck Message Board Network

VOoDoO70 · 10-16-2018, 11:55 AM

I replaced the existing Edelbrock 600cfm carb with Fitech's 400hp unit on my 350/Th350 setup. My question is what are you guys using to marry up your throttle linkage. The current one doesn't quite reach as it also hits the chrome bracket below it when in full throttle position. I have the bar type setup and need to figure out what's needed to run the new one correctly. I've attached a pic of what my currrent setup looks like. Any pics/suggestions is greatly appreciated.

10-16-2018, 11:55 AM	#1
VOoDoO70 Registered User Join Date: Mar 2018 Location: TEXAS Posts: 25	Fitech throttle linkage help I replaced the existing Edelbrock 600cfm carb with Fitech's 400hp unit on my 350/Th350 setup. My question is what are you guys using to marry up your throttle linkage. The current one doesn't quite reach as it also hits the chrome bracket below it when in full throttle position. I have the bar type setup and need to figure out what's needed to run the new one correctly. I've attached a pic of what my currrent setup looks like. Any pics/suggestions is greatly appreciated. Attached Images Last edited by VOoDoO70; 10-16-2018 at 03:26 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.