1966 Chevy C10 alignment?

[COCONUTS]

I just got through replacing a drivers side lower control arm, new coils and shocks all around, lower ball joints and both sides tie rod assemblies. I installed all stock parts and didn’t lower the truck at all. I also replaced the panhard (trac) bar with an adjustable bar and have the rear end dead center now.

My question is what are the “toe” settings on this year truck?

I have read 1/8th total IN....1/16th in on each side.

I also saw different charts posted here that are totally different. I didn’t disrupt the upper camber settings at all. I was going to set my toe in or out using a string from back to front and measure the in-out on the front wheels so I can use the truck until I can get it in to the alignment shop. I’m involved with a project and need my truck to get lumber, plumbing and electrical supplies.

This is my daily driver.

Thank you for any replies.

Greg