Show me your cans - The 1947 - Present Chevrolet & GMC Truck Message Board Network

fdbdw · 12-10-2018, 01:54 PM

Previous owner did not run a pcv , I’m blowing valve cover gaskets due to the excess crank case pressure so I’m putting together a system. 396 bbc, lumpy cam, low vacuum. I’m going to try PCV454, basically a hollow can with a pin hole at the bottom. I am also planning on adding a catch can. I would like to get some ideas on where/how to mount it. If you have one I would like to see how it was mounted.
Thank you

12-10-2018, 01:54 PM	#1
fdbdw Registered User Join Date: Jan 2009 Location: colorado springs Posts: 479	Show me your cans Previous owner did not run a pcv , I’m blowing valve cover gaskets due to the excess crank case pressure so I’m putting together a system. 396 bbc, lumpy cam, low vacuum. I’m going to try PCV454, basically a hollow can with a pin hole at the bottom. I am also planning on adding a catch can. I would like to get some ideas on where/how to mount it. If you have one I would like to see how it was mounted. Thank you



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.